Use this guide to verify that the card dispenser is getting the correct voltage from the power source (control head / distribution board).
Step-by-step guide
Verify Source Voltage
- Set multi-meter to DC mode
- Connect black probe to orange pin
- Connect red probe to green pin
- Verify that multi-meter displays 12V
Wiring Reference
Pin Location | CCI Wire Color | 12VDC Connections | Operations Guide |
---|---|---|---|
1 | Orange | 0V | Source Voltage |
2 | Green | 12VDC | |
3 | COMMON | Vend Switch 30ms or longer switch closure to vend card | |
4 | NORMALLY OPEN | ||
5 | LIT BUTTON / LAMP | READY-TO-VEND SIGNAL Enables a lamp to be lit when unit is ready to dispense cards | |
6 | 5VDC | ||
7 | NORMALLY OPEN | RESET SWITCH | |
8 | COMMON | ||
9 | LIT BUTTON / LAMP | RESET & JAM SIGNAL Enables a lamp to be lit when card has not been dispensed. If a card jams, or fraud is experiences, a flashing output will occur. | |
10 | 5VDC | ||
11 | LIT BUTTON / LAMP | DISPENSER EMPTY SIGNAL | |
12 | 5VDC |
Related articles