Skip to end of banner
Go to start of banner

Terminating Cat. 5 Network/Patch Cable Ends

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

Table of Contents
Purpose
This guide will teach you on how to make your own cat 5 cabling.
 

Requirements

  • CAT 5 Cable
  • When setting up the wiring we want to make sure you are using the 568-B Wiring Diagram
     

Instructions

  1. Cut the cable to the length that you will need. If you are planning to use boots, this would be a good time to slip them on. Place each boot facing out on the cable.

  2. Skin the cable about 1.5down. For fast and dependable skinning we recommend our QuickTreX™ EZ Cable stripper.
  3. Remove all of the twists in the cables pairs.

    Use a piece of the removed insulation to make it easy to remove the twists from each pair. Un-twist each pair, and straighten each wire between the fingers.

  4. Cat 6 cable has a center spine that needs to be removed. Pull on the spine and fold the pairs back. Then cut the spine as close to the cables end as possible.

  5. Place the wires in the order.

  6. Bring all of the wires together, until they touch. Hold the grouped (and sorted) wires together tightly, between the thumb, and the forefinger.
    At this point, recheck the wiring sequence with the diagram.

  7. Cut the wires on a very sharp angle to make it easier to install the load-bar(in the next step).

  8. Insert the load bar on the wires one wire at a time. This is why we recommended cutting the wires on an angle. 

  9. Check the wiring sequence one more time. Than slide the load bar down all the way and make a straight cut about 0.25 past the load bar.

  10. Insert the connector onto the load bar assembly. Hold the plug with the copper connectors up and the locking clip facing down. 

    In this configuration, the Brown Pair of wires should be to the right side
     
  11. For Crimping we recommend a Ratchet Crimper for RJ-45 and RJ-11/12.Push the connector all of the way in and then squeeze down all the way on the crimper. Remove the connector from the crimper body.

  12. Slide the boots (if used) all the way up to the connector. If necessary, use a tapping motion as shown in the illustration.

  13. Repeat the procedure on the other end of the cable using the same wiring diagram.
  14. Test the cable using a high quality four pair tester.

  • No labels