If your Huebsch washer shows dashes (----) or 8888 then follow this guide.

Equipment Models

This document is valid for the following equipment models...

Instructions

Make sure your card reader is connected to the washer and setup in the LaundryCard software correctly
Toggle switch on washer computer to enter program mode
Display will read TSFL
Press Asterisk button (Quick Wash Warm)
Press green (Start) button repeatedly until washer display TSFL again
Toggle switch back of washer computer to set back to run mode
Check if card reader updates pricing on washer. If so test start the washer.
1. If display of washer is NOT updating the price power cycle the washer
2. If pricing still does not update you may need to reset WCRD.
  Easiest way to do this is:
  1. Insert manager card into X-Changer
  2. Press Manager
  3. Press Equip Setup
  4. Press Config (Agree to the alert)
  5. When Config page loads press on the Done button
  6. Readers in store should refresh and washer should now be talking to reader.