3449 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Vending
Manufacturer: Vend-Rite
Make: Vend-Rite
Model Length: Not Set

Machines shipped after Fall 2011 have the newer style white bracket that accepts either a reader or coin mech.

Machines shipped in 2019 or later are not compatible with the C-0972 or C-6972 mounting brackets.

Associated Models

DVM360
VM120BN
VM120C
VM120D
VM120M
VM240
VM240BN
VM240C
VM240D
VM240M
VM360
VM360C
VM360D
VM360DS
VM360M

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Install Mounting Hardware

Connect Machine Interface Harness

Connect and Mount Reader

Feed remaining harness ends through the mounting hole as described in the FasCard F2/F3 Reader Installation Guide - Front Mount.
Connect the black, 10-pin connection of the C-6124-MDB Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
Connect the clear, 3-pin connection of the C-6124-MDB Power Harness to port 1.
Secure the FasCard reader to base as described in the FasCard F2/F3 Reader Installation Guide - Front Mount.

CCI Software Configuration

Machine Control	Pulse	Serial
MDB	NOT SUPPORTED	Vending - MDB Level 1