3286 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Washer
Manufacturer: Continental
Make: Continental
Model Length: 14 to 16

G-Flex Hard-Mount Washers

When setting up, customer will have to relay what extra option the machine is setup for. Select the appropriate equipment type when setting up equipment on FasCard/LaundryCard.

"Continental ProfitPlus Washer" is only a placehold/legacy equipment. New equipment should be using v45 or newer machine firmware and will require selecting on of the following:
• "Continental ProfitPlus Washer - Delicate"
• "Continental ProfitPlus Washer - Extra Spin"
• "Continental ProfitPlus Washer - Sanitize"

Associated Models

RMG033X113211111
RMG033X1132111111
RMG040X113200000
RMG040X113211100
RMG040X113211111
RMG040X1132111111
RMG040X13211111
RMG055X113211000
RMG055X113211100
RMG055X113211111
RMG055X1132111111
RMG055X11321111111
RMG055X1321111
RMG055X13211111
RMG055X213211111
RMG070X113211000
RMG070X113211111
RMG070X1132111111
RMG070X2131211111
RMG070X213211000
RMG070X213211110
RMG070X213211111
RMG070X2132111111

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Install Mounting Hardware

Connect Power

Connect Coin Sense Harness

Connect Machine Interface Harness

Connect and Mount Reader

Machine Configuration

ProfitPlus Controls

Connect the washer and open the door. The display will show door.
Press and hold down key 1 until the Cod report appears on the display.
Enter the access code into the menus by pressing the sequence of eight keys of the code without interruption. In basic configuration (when the machine is delivered) the access code to ADVANCED MODE is: 12341234.
If the sequence entered is correct, the display will show Pro, corresponding to the first menu ADVANCED MODE.
Keys 2 and 4 allow the selection of the precedent table menus. The menu selected is shown on the display following its keyword. To enter in it, press key 1 when displaying it.
Navigate to Mod > ID and set value to '1'.
Exit ADVANCE MODE.

CCI Software Configuration

Machine Control	Pulse	Serial
ProfitPlus	SingleVend (Relay) / 500ms	Continental ProfitPlus Washer