2014 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Dryer
Manufacturer: Maytag
Make: Maytag
Model Length: Not Set

• 1) If factory coin drop adapter harness is not available and coin drop connection on board is not compatible with C-5344 start harness, use C-5302 start harness.

Associated Models

MDG32PC2AL
MDG32PC3AL
MDG32PC3AW
MDG32PC3AW1

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Install Mounting Hardware

Connect Power

Connect Coin Sense Harness

I-S0012

Part #: C-5343

Desc 1: Coin Sense Harness (SA)

Desc 2: ADC Phase 5

Qty: 1

Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-5343 Coin Sense Harness to the harness connected to the Coin Drop.

I-S0040

Part #: C-6348