Versions Compared

Version Old Version 1 New Version Current
Changes made by

David Bussman

David Bussman

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall kit
KitID11821190
KitDescPulse - Coin and Card

  1. Run C-5262 Machine Start Harness and C-6360 Coin Sense Harness to the lower pocket control board.

  2. Connect C-5262 Machine Start Harness to the Coin 1 connection and the C-6360 Coin Sense Harness to the coin drop designated for the lower pocket.

  3. Locate area to mount C-6410 Pulse Stack Add-On Board.

    1. Must be close enough to reader mounting location to connect the harness to.

    2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)

  4. Clean mounting location to remove any dust and residue if needed.

  5. Remove the sticker from the back of the C-6410 Pulse Stack Add-On Board to expose the adhesive and apply to the mounting location.

  6. Connect the C-6410 Stack Add-on Board to port 5 (Serial Connection Port) on the card reader.

    1. Connect the C-5262 Machine Start Harness connected to the lower pocket Machine Control Assembly to the J1 connection on the C-6410 Stack Add-on Board.

  7. Connect the C-6360 Coin Sense Harness connected to the upper pocket Coin Drop to port 3 (Coin 1 Sense Harness Connection Port) on the card reader.

  8. Connect the C-6360 Coin Sense Harness connected to the lower pocket Coin Drop to port 4 (Coin 2 Sense Harness Connection Port) on the card reader.

...