_1190

Owned by David Bussman
Last updated: Nov 21, 2024
1 min read
 I-X0049

Part #:

Desc 1: Kit ID: I-X0049

Desc 2:

   Qty: 0

Part #: C-6360

Desc 1: Coin Sense Harness

Desc 2: Female taps, Rq. Male

   Qty: 1

Part #: C-5262

Desc 1: Machine Start Harness

Desc 2: 40" - Male taps, Rq. Female

   Qty: 1

Part #: C-6410

Desc 1: F3, SLV Stack Add On Dongle

Desc 2: Pulse / SingleVend

   Qty: 1

  1. Run C-5262 Machine Start Harness and C-6360 Coin Sense Harness to the lower pocket control board.

  2. Connect C-5262 Machine Start Harness to the Coin 1 connection and the C-6360 Coin Sense Harness to the coin drop designated for the lower pocket.

  3. Locate area to mount C-6410 Pulse Stack Add-On Board.

    1. Must be close enough to reader mounting location to connect the harness to.

    2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)

  4. Clean mounting location to remove any dust and residue if needed.

  5. Remove the sticker from the back of the C-6410 Pulse Stack Add-On Board to expose the adhesive and apply to the mounting location.

  6. Connect the C-6410 Stack Add-on Board to port 5 (Serial Connection Port) on the card reader.

    1. Connect the C-5262 Machine Start Harness connected to the lower pocket Machine Control Assembly to the J1 connection on the C-6410 Stack Add-on Board.

  7. Connect the C-6360 Coin Sense Harness connected to the upper pocket Coin Drop to port 3 (Coin 1 Sense Harness Connection Port) on the card reader.

  8. Connect the C-6360 Coin Sense Harness connected to the lower pocket Coin Drop to port 4 (Coin 2 Sense Harness Connection Port) on the card reader.