| Panel | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
| This page is intended to guide the installer on the steps involved for a C-6204 power harness for Alliance ACA machines. This guide is meant to cover the installation processes for F1 and F2 readers. |
| Multiexcerpt include | ||||||
|---|---|---|---|---|---|---|
|
| Multiexcerpt include | ||||||
|---|---|---|---|---|---|---|
|
Required parts
| Bw part list | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Step-by-step guide
| Warning | ||
|---|---|---|
| ||
This harness is designed only to be used with the 12vDC accessory connections (H10) found on Alliance ACA control boards. Do not connect to any other connections, or modify harness to connect to an alternate power source. |
- Locate the H10 connection on the ACA control board.
- Plug in the (a.) 12vDC Harness Connector into the H10 connection.
- Locate a nearby Chassis Ground Screw. Connect the (b.) Ground Harness Connector to the Chassis Ground Screw.
Run the (c.) FasCard Power Connector to the FasCard reader mount.
Note title Routing the harness This may differ between ACA models. Please be sure to route around any potential components that may damage the harness. - Connect the (c.) FasCard Power Connector to the Power Harness Connection Port.
Related documentation
| Filter by label (Content by label) | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|