/
C-6204 ACA Power Harness Installation Guide

C-6204 ACA Power Harness Installation Guide

Owned by David Bussman
Last updated: Oct 14, 2022 by Chris Kite

Required parts

Step-by-step guide

Electrical warning

This harness is designed only to be used with the 12vDC accessory connections (H10) found on Alliance ACA control boards. Do not connect to any other connections, or modify harness to connect to an alternate power source.

  1. Locate the H10 connection on the ACA control board. 


    Example of an ACA control board. Position of the H10 connector may differ based on form factor.
    Example of an ACA control board. Position of the H10 connector may differ based on form factor.




  2. Plug in the (a.) 12vDC Harness Connector into the H10 connection.




  3. Locate a nearby Chassis Ground Screw. Connect the (b.) Ground Harness Connector to the Chassis Ground Screw.




  4. Run the (c.) FasCard Power Connector to the FasCard reader mount.




  5. Connect the (c.) FasCard Power Connector to the Power Harness Connection Port.


    F1 power harness connector
    F1 power harness connector
    F2 power harness connector
    F2 power harness connector

Related documentation