Page Comparison

The following steps assume the start and coin sense harnesses are already connected to the upper pocket controlharness for the upper pocket control is already connected.

1. Run C-0110-TOP-144 Machine Start Harness to the lower pocket Machine Control Assembly.

2. Pulse Setup

   1. Connect the C-0110-TOP-144 Machine Start Harness to the H3 connection on the Machine Control Assembly.

   2. C-0110-CP Jumper Plug is not used, but can be retained in case of future serial communication usage usage.

   Serial Setup

   1. Connect the C-0110-TOP-144 Machine Start Harness to the H3 connection on the Machine Control Assembly.

   2. Connect the C-0110-CP Jumper Plug to the H6 connection on the Machine Control Assembly.

3. Locate area to mount C-6411 Serial Stack Add-On BoardDongle.

   1. Must be close enough to reader mounting location to connect the harness to.

   2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)

4. Clean mounting location to remove any dust and residue if needed.

5. Remove the sticker from the back of the C-6411 Serial Stack Add-On BoardDongle to expose the adhesive and apply to the mounting location.

6. Connect the white, 7-pin connector from C-6411 Stack Add-on Dongle to port 5 (Serial Connection Port) on the card reader.

   1. Connect the C-0110-TOP

   to the H3 connection on

   1. Machine Start Harness connected to the upper pocket Machine Control Assembly to Unit 1 on the Stack Add-on Dongle.

   2. Connect the C-0110-TOP-144 Machine Start Harness connected to the lower pocket

   's

   1. Machine Control Assembly to Unit 2 on the Stack Add-on Dongle.

7. Bend the side tabs of the C-0940 Vault Bracket outward and install into the coin vault for the lower pocket. The tabs should snap into place securing the bracket.

8. Apply the C-5033 Label over the coin drop opening for the lower pocketpocket’s coin drop.