Versions Compared

Old Version 1

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Choose Machine Config to assign each machine ID to an equipment type as configured earlier

Info

Prior to this step it is advisable to walk the location with the cabling layout provided by CCI and identify the equipment types and locations for all the machines on the drawing.

...

.  These steps MUST be done on the X-Changer and cannot be done remotely.

  1. Insert Manager Card.
  2. Select System Setup.
  3. Select Card Reader Setup
  4. Select Machine Config
    Image Added

This is the Machine Overview Page. This page sets the equipment to the correct machine number and the correct Line the machine is on.

Note

Pay close attention to the line number that the equipment is on. Also remember washers start at 001, dryers start at 101 and accessory devices start at 201.


  1. Touch or click on the first Machine ID on the list.
    Image Added

  2. Referencing the store layout that was provided with the system

    enter the appropriate line number, card reader address (almost always the same as the Machine ID), and the Equipment ID (use the table below to choose the appropriate ID).
    Image Removed

    , complete the fields on this page.
    Image Added

  3. Once complete,

    choose the

    choose Save

    button

    ,

    then the

    then Next

    button

     to move to

    move

    the next numeric machine ID and repeat step 2. You must click SAVE and NEXT after each Equipment Type has been entered or it will not save the previously entered information.  

  4. Once you have entered in the values for each of the machines in that numeric series, choose the Back button to return to the Machine ID listing page. 
    Note

    Typically washers start at number 1, and dryers start at 101 representing dryer number 1.

  5. Using the scroll bars or scroll buttons on the screen to find the next numeric series and repeat steps 2 and 3.
    6. Once complete with all machine types as identified on the store layout, choose Done
Note

BE SURE TO INCLUDE ANY ACCESSORY DEVICES WHEN CONFIGURING HARDWARE, SUCH AS DOORS, VENDING MACHINES, ETC.

  1. Once complete with all machine types as identified on the store layout, click Back and then Done.  

    FieldDescription
    Card Reader AddressThe number of the machine in the row.
    Line NumberThe line number the machine is on. (Example Line 0)
    Equipment Type IDThis can be found in the list below the fields. 


Your equipment should be ready to start. At this time, assuming all readers have been programmed and if the information was entered correctly, the readers will start to download the appropriate firmware. This may take approximately 15 minutes.

If the readers complete the download and the readers continue to say, “See Attendant”, there may be an error in the configuration and the equipment setup should be checked for accuracy. If the issue persists, Contact CCI technical Support at (630) 930-5115.