Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: WEB-43
Panel
titlePurpose
borderStylesolid
ExcerptInstructions on replacing a hard drive in Dell computer models: GX520 through XE2


Note
 Card

Card Concepts Inc takes no responsibility for data loss due to human error, hardware failure, or other such circumstances.

Panel
titleTable of Contents
borderStylesolid
Table of Contents

 

 

 

Before opening the computer housing, make sure all  power is disconnected from the unit.


Equipment Models

This document is valid for the following equipment models...

Remove the housing cover.
Image Removed
    • Dell Optiplex GX520
    • Dell Optiplex GX745
    • Dell Optiplex GX755
    • Dell Optiplex GX760
    • Dell Optiplex GX780
    • Dell
  • XE
  • Dell GX520

Requirements

  • New or replacement hard drive

Instructions

Warning

Before opening the computer housing, make sure all  power is disconnected from the unit.

 

  • Locate and slide, to open the computer housing.
    Image Removed
      • Optiplex XE

    Instructions

    1. Locate and pull the release tab to open the computer case, then remove the cover. 

      Image Added    Image Added



    2. Locate the hard drive and the two, blue hard drive tray's blue release tabs. Squeeze , tabs together and then gently lift the hard drive out of the computer.
      Image Removed
      Image Removed
    3. Locate,and gently unplug the two cables shown below in the picture from the rear of hard drive. 
      Image Removed
      Image Removed 
    4. Locate the two blue tabs on the hard drive case.Gently push out to release the hard drive from the case. Lift the hard drive out
      Image Removed
      Image Removed
    5. When replacing with new hard drive line up the blue tabs with the holes on the side of the hard drive,and snap the hard drive back into the case. If you have to force the hard drive in, it is not lined up correctly, stop and try again
      Image Removed
    6. Once the hard drive is back into the plastic case,re-attach the two cable taken out in step 2.
      Image Removed
    7. Line the black rear tab of the hard drive case with the slotted openning on the computer case
      Image Removed
    8. Locate,and align the front end of the hard drive plastic case with the pins inside the computer case and press down gently. Snapping the hard drive and case back into place.
      Image Removed
      Image Removedtray upward, then unplug both attached cables.

      Image Added

      Image Added



    9. Remove the hard drive from its tray by pushing down on the blue release tabs, and lifting the drive out. Install a new drive to the tray.

      Image Added   Image Added



    10. Reinstalling tray: line up the black tab with the slot on the computer case, and make sure the blue tabs click securely into place.

      Image Added    Image Added



    11. Closing the computer case: Line up the three wall lid tabs, with the slots on the computer housing
      Image Removed Once the three tabs are in place close the computer housing gently snapping it shut.
      Image Removed

      Image Added    Image Added

     

     

     

     

     

     

     

     

     

     

     

     

     

    .

     

     

     

     

     

     

     

     

     

     

     

    Tips & Warnings