Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Small Dryer (Stack)
Manufacturer: Alliance
Make: Speed Queen
Model Length: 8
Associated Models
BSE907WF
HSET17WF
SSE107WF
SSE907WF
SSE917WF
SSET07WF
SSG109WF
SSG119WF
SSG909WF
SSGT09WF
SSGT19WF
SSGY09WF
SSGY19WF
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Connect Machine Interface Harness
Part #: C-5300-NC
Desc 1: Machine Start Harness
Desc 2: Aliiance - Normally Closed
Qty: 1
Connect the C-5300-NC Machine Start Harness to the Coin 1 connection on the Machine Control Assembly.
Part #: C-5256
Desc 1: Machine Start Harns (pulse)
Desc 2: 20" - Male taps, Rq. Female
Qty: 1
Connect the C-5256 Machine Start Harness to the factory coin harness previously connected to the micro switch on the coin drop.