Skip to end of banner
Go to start of banner

3659 Reader Install Guide

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Current »

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Top Load Washer
Manufacturer: Wascomat
Make: Encore
Model Length: 9 to 11

Coin models and card models both use the metercase and can use the same card only installation kit.

Associated Models


WMTW4371C2FMI
WMTW4371M
WMTW4371MC2
WMTW4371MCWDC

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Install Mounting Hardware

Connect Power

Connect Coin Sense Harness

Connect Machine Interface Harness

Connect and Mount Reader

Machine Configuration

Encore FLW Controls

  1. Press the Service Switch to enter Service Mode. The display will go blank.

  2. Press the Heavy Soil and Extra Rinse buttons simultaneously. The display will show either "0 00" if in coin mode and "1 00" if in card mode.

  3. If in coin mode, press the Start button. The display will begin flashing.

  4. Press the Cold button to change the left-most digit from "0" to "1".

  5. Press the Start button. The display will stop flashing.

  6. Press the Service Switch to exit Service Mode.

  • No labels