Overview
This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below. This guide further assumes that all relevant Cat5 cables have been run to the point of connection for the LaundryCard reader being installed. Further information regarding cabling and mounting can be found in the LaundryCard Kit Installation Guidelines.
Install Header
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
LaundryCard Reader V3 - RevB Multi-Vend / BootloaderRequired Hardware
Card Reader
Part ID Description Image C-0103-B
LC Tools
- Various Cat5 cables
- If terminating cables, include Cat5 RJ-45 stripper/crimper
- Cat5/RJ-45 line tester
- 3/32 allen key (card reader screws)
- Philips Screwdriver w/ multiple bits
- Flathead Screwdriver
- Standard socket set
- Utility Knife
- Cable/Zip Ties
Ports
|
|
Warnings
Confirm machine power is disconnected before beginning installation! Use caution and appropriate protection to prevent hand and eye injury during installation!
Additional Information
Additional Information
Unverified
These instructions and kit hardware have not been verified or tested by Card Concepts Inc. and are used at the installers own risk.