Skip to end of banner
Go to start of banner

_1176

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

 I-X0042

Part #:

Desc 1: Kit ID: I-X0042

Desc 2:

   Qty: 0

Part #: C-5374R1-144

Desc 1: FC-LC Start Harness

Desc 2: Pulse Start Harness

   Qty: 1

Part #: C-6410

Desc 1: F3, SLV Stack Add On Dongle

Desc 2: Pulse / SingleVend

   Qty: 1

Part #: C-6971

Desc 1: FC Mounting Bracket

Desc 2: Fagor Machine

   Qty: 1

Part #: C-5033

Desc 1: Label

Desc 2: 4-5/8" x 3-1/2"

   Qty: 1

  1. Disconnect the coin drop from the lower pocket’s machine control assembly and connect to the C-6373-144 Coin Sense Harness.

  2. Connect the C-5374R1-144 Pulse Start Harness to the 6-pin connector on the CN8 extension harness for the lower pocket’s machine control assembly.

  3. Run both of the harnesses back to the card reader’s mounting location.

    domus-fagor_dryer_coin_connection.jpg

  4. Locate area to mount C-6410 Pulse Stack Add-On Board.

    1. Must be close enough to reader mounting location to connect the harness to.

    2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)

  5. Clean mounting location to remove any dust and residue if needed.

  6. Remove the sticker from the back of the C-6410 Pulse Stack Add-On Board to expose the adhesive and apply to the mounting location.

  7. Connect the white, 6-pin connector from the C-5374-144 Machine Start Harness to the J1 connection on the C-6410 Pulse Stack Add-On Board.

  • No labels