| Part ID | Description |
|---|---|
| C-1004B |
| Required Tools | |
| Phillips head screwdriver |
|
Socket wrench Socket: 11/32" |
|
The installer will need to install the MEI credit card bezel to the front of the X-Changers. You will need an 11/32” deep well socket and a #2 Philips head screwdriver.
- Remove the cash box from the bill acceptor located on the inside of the X-Changer door.
- Unplug the power (smaller) and data (larger) cables from the right side of the bill acceptor.
- Remove the four 11/32” nuts holding the bill acceptor on the door and set aside. Take care not to let it drop to the floor.
- Pull the bill acceptor out of the X-Changer door towards inside and place on a flat surface.
- Place the Credit Card Bezel on the Bill Acceptor and attach with the provided screws.
- Place bill acceptor with the attached MEI credit card bezel back into the door of the X-Changer.
%20(Medium).JPG?version=2&modificationDate=1645630385843&cacheVersion=1&api=v2&width=192&height=288)
- Put the green ground cable onto the screw stud and replace the four 11/32 kep nuts and hand tighten.
- Thread serial cable around the door harness to the back of the computer.
.JPG?version=1&modificationDate=1547046964913&cacheVersion=1&api=v2&width=375&height=250)
- Install the serial adapter to the open port on the back of the computer.
Add pic here for the mei serial adapter - Plug the flat serial connection into the adapter until it clicks.
- Plug the round barrel connector into the adapter, then plug into an available outlet on the surge protectors. Do not plug into the battery backup at the bottom.