On this Page
Overview
Disconnect any electrical device from power before performing any work on the device. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks.
Card Concepts Inc. takes no responsibility for the accuracy of this document or any damage that may occur to target equipment. Technical Support recommends using all appropriate safety equipment (such as hand and eye protection) during execution of the instructions below.
Required Hardware
| C-0550 | C-0525 |
|---|---|
Recommended Tools and Supplies (Not Included)
- Phillips Screwdriver
- 3/16" Hex Driver
Installation
Step 1 - Remove Control Head from X-Changer Cabinet
- Flip the white rocker switch on the rear of the control head to the 'Off' position.
- Disconnect all cables from the front and rear of the control head unit.
- Remove the screws securing the control head wings to the X-Changer frame.
|
|
Step 2 - Remove Control Head Wings
- Using the 3/16" Hex driver, remove the screws securing the wings to the control head.
- Set screws aside for reassembly.
|
|
Step 3 - Open Control Head
- Remove the screws indicated in the composite image below.
- Slowly lift the top panel - internal cable connections will prevent it from being removed entirely.
- Disconnect the USB cable.
- Disconnect the parallel (ribbon) cables.
- Top panel may now be completely removed.
|
|
Step 4 -
- Step 4 part 1.
Step 5 -
- Step 5 part 1.