0088 LaundryCard Reader Install Guide

Owned by Brett Norrell (Deactivated)
Last updated: Jan 24, 2024 by Chris Kite
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Tumble Dryer (Single)
Manufacturer: Dexter
Make: Dexter
Model Length: Not Set

Associated Models


DRC55Q
DRC55QSS
DRC55QWHT

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Install Mounting Hardware

 I-M0018

Part #: C-0015

Desc 1: Label

Desc 2: Reader Cover Label

   Qty: 1

Part #: C-0031

Desc 1: Label

Desc 2: Dexter Instruction Panel

   Qty: 1

Part #: C-0134

Desc 1: Standoff

Desc 2: 8-32" x 1" - Hex

   Qty: 2

Part #: C-0905

Desc 1: Drop Cover

Desc 2: 2-3/8" x 4-5/8"

   Qty: 1

Part #: C-0906

Desc 1: Spacer Plate

Desc 2: 5 1/2" x 4 3/8"

   Qty: 1

Part #: C-0936

Desc 1: Vault Mount Bracket

Desc 2:

   Qty: 1

Part #: C-1043

Desc 1: Screw

Desc 2: 8-32 x 1-3/4" - Flat

   Qty: 2

  1. Remove existing coin box and coin drop.

  2. Bend the side tabs of the C-0936 Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

  3. Attach the C-0134 Standoffs to the Bracket.

  4. Install C-0905 Drop Cover where the coin drop was previously installed. Secure in place using existing hardware.

    1. Apply C-0031 Label on to Drop Cover.

  5. Place C-0906 Spacer Plate over coin vault opening between the reader and machine.

Connect Machine Interface Harness

 I-T0040

Part #: C-5256

Desc 1: Machine Start Harns (pulse)

Desc 2: 20" - Male taps, Rq. Female

   Qty: 1

  1. Connect the C-5256 Machine Start Harness to the harness previously connected to the micro switch.

Connect and Mount Reader

  1. Feed remaining harness ends through the mounting hole as described in the LaundryCard Kit Installation Guidelines.

  2. Connect the free end of the C-5256 Machine Start Harness to the appropriate port.

    1. For pulse start harnesses (white connector), connect to port 2 (Pulse Connection Port) as shown in the image above.

    2. For serial start harnesses (black connector), connect to port 1 (Serial Connection Port) as shown in the image above.

  3. Secure the LaundryCard reader to the machine as described in the LaundryCard Kit Installation Guidelines.

Machine Configuration

TODO

CCI Software Configuration

Machine ControlPulseSerial
A-Series (1.0)SingleVend (Relay) / 55ms*NOT SUPPORTED*

Additional Resources