Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Washer
Manufacturer: ONNERA Group
Make: [VARIES]
Model Length: 10
Associated Models
DHU100CHWTOUCHII
DHU25HWTOUCHII
DHU40HWTOUCHII
DHU65HWTOUCHII
DHU80CHWTOUCHII
DLU100CHW
DLU135HW
DLU135HWTOUCHII
DLU25TPSHW
DLU30HWTOUCHII
DLU40HW
DLU40HWTOUCHII
DLU40TPSHW
DLU50HWTOUCHII
DLU60TPSHW
DLU65HW
DLU80CHWTOUCHII
FWH80TP2HW
FWS25TP2HW
FWS30TP2HW
FWS40TP2HW
FWS60TP2HW
FWS80TP2HW
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Install Mounting Hardware
Connect Power
Connect Coin Sense Harness
Connect Machine Interface Harness
Connect and Mount Reader
CCI Software Configuration
Machine Control | Pulse | Serial |
---|---|---|
Touch II | SingleVend (Relay) / 150ms | *NOT SUPPORTED* |
Touch Plus | SingleVend (Relay) / 150ms | *NOT SUPPORTED* |
Additional Resources
- How to Program Address on a FasCard Reader
- FasCard Admin Site - Equipment Setup
- FasCard Admin Site - Machine Setup
- FasCard Admin Site - Pricing & Features Schedule
- F1 Reader Mounting Guide
- FasCard F2/F3 Reader Installation Guide - Front Mount
- FasCard Installation Videos
- FasCard Kit Installations - Machine Configurations & Related Documents