0578 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Tumble Dryer (Stack)
Manufacturer: Dexter
Make: Dexter
Model Length: Not Set

Associated Models

DDAD30KCA
DDAD30KCA65
DDAD30KCA65EC
DDAD30KCB65
DDAD30KCB65CN
DDAD30KCB65CNTS
DDAD30KCB65NC
DDAD30KCB65TS
DDAD30KCB65US
DDAD30KCB65USTS
DDAD30KCK
DDAD30KCS
DDAD30KCS65
DDAD30KCS65CN
DDAD30KCS65EC
DDAD30KCS65ECTS
DDAD30KCS65TS
DDAD30KCS65US
DDAD30KCS65USTS
DDAD30KCW
DDAD30KCW65
DDAD30KCW65CN
DDAD30KCW65CP
DDAD30KCW65EC
DDAD30KCW65US
DDAD30KCX65CN
DDAD30KCX65US
DDAD30KCY65CN
DDAD30KCY65US
DDAD30KCY65USPS
DDAD30KCZ65US
DDAD50KCA65
DDAD50KCA65EC
DDAD50KCB65CN
DDAD50KCB65CNTS
DDAD50KCS
DDAD50KCS65
DDAD50KCS65CP
DDAD50KCS65EC
DDAD50KCS65TS
DDAD50KCS65US
DDAD50KCW65
DDAD50KCW65CN
DDAD50KCW65EC
DDAD50KCW65TS
DDAD50KCX65US
DDAD50KCY65US
DDAD50KCY65USTS
DDAG30KCS65
DDAG30KCW65
DDTD30KCS
DDTD30KCS65
DDTD30KCS65ECXC
DDTD30KCS65XC
DDTD30KCW65ECXC
DDTD30KCW65XC

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Install Mounting Hardware

Connect Power

Connect Coin Sense Harness

Connect Machine Interface Harness

Connect and Mount Reader

CCI Software Configuration

Machine Control	Pulse	Serial
A-Series (1.0)	SingleVend (Relay) / 55ms	NOT SUPPORTED