Maytag Configuration - FasCard
Overview
Use this guide when configuring Maytag machines in FasCard.
Assumptions
This document assumes the installer is familiar with programming Maytag washers. This procedure is required to allow the CCI card reader to start the washer in Gen 1 mode.
Configuration: Singlevend (Recommended)
Maytag machines are setup up just like any other singlevend machine with the following exceptions:
Relay Type | Pulse Length | Pulse Interval | Usage |
|---|---|---|---|
Pulse | 32 | 250 | Standard pulse harness (white connector) |
MLV+ (Recommended) | 24 | 150 | Digital pulse harness (black connector) |
Super Cycle
If supporting the Super Cycle option on the machine, use the Extra Option singlevend mode.
Small washers show the option for 30 approximately seconds. Large chassis washers show the option for approximately 60 seconds.
Machine Configuration
Enable the "Clear Escrow" setting on the machine if available.
Configuration: Maytag Gen 1 (Legacy)
This configuration method is no longer supported!
NOTE: Cycle Pricing and Deluxe/Ultimate pricing are not supported.
Keypad Functions
Single Price
Setting | Value |
|---|---|
Value of Coin 1 | 0.25 |
Regular Cycle Price | 2.00 |
Price Display | Hidden |
Coin/Debit | Coin.Card |
Clear Escrow | Yes |
Special Pricing... | Off |
Enhanced Pricing... | None |
Super Cycle
Use above settings plus the following:
Setting | Value |
|---|---|
Enhanced Pricing | Upgrade |
Super Cycle Display | Yes |
Super Cycle Price | 0.25 |
Deluxe Cycle Display | No |
Ultimate Cycle Display | No |