_1161
- David Bussman
Part #: C-0940
Desc 1: Vault Cover
Desc 2: 3-7/8" x 2-3/4"
Qty: 1
Part #: C-5353R1-144
Desc 1: Machine Start Harness (SA)
Desc 2: 144" - LaundryLux
Qty: 1
Part #: C-6410
Desc 1: F3, SLV Stack Add On Dongle
Desc 2: Pulse / SingleVend
Qty: 1
Part #: C-0907
Desc 1: Drop Cover
Desc 2: Wascomat TD 3030
Qty: 1
Part #: C-1062
Desc 1: Nut
Desc 2: 4-40 - Kep
Qty: 4
Part #: C-0136
Desc 1: Screw
Desc 2: 4-40 1/2" pan head zinc
Qty: 4
The following steps assume a start harness is already connected to the upper pocket control.
Locate area to mount C-6410 Pulse Stack Add-On Board.
Must be close enough to reader mounting location to connect the harness to.
Must be on a surface that does not received direct exposure from any heating elements (If applicable.)
Clean mounting location to remove any dust and residue if needed.
Remove the sticker from the back of the C-6410 Pulse Stack Add-On Board to expose the adhesive and apply to the mounting location.
Connect the C-5353R1-144 Machine Start Harness to the Coin 1 connector on the lower pocket Machine Control Assembly.
Connect the white, 6-pin connector from the C-5353R1-144 Machine Start Harness to the J1 connection on the C-6410 Pulse Stack Add-On Board.
Insert the C-0940 Vault Cover into the coin vault for the lower pocket’s control.
Install the C-0907 Coin Drop Cover using the (4) C-0136 4-40 1/2” Pan Screws and (4) C-1062 4-40 Kep Nuts to secure in place.