_755
- Chris Kite
Part #: C-0015
Desc 1: Label
Desc 2: Reader Cover Label
Qty: 1
Part #: C-0144
Desc 1: Screw
Desc 2: 8-32 x 2" - Flat
Qty: 2
Part #: C-0930
Desc 1: Mounting Bracket
Desc 2: Unimac/ADC
Qty: 1
Use the C-0930 Mounting Bracket to mark out the center opening for the card reader and the lower set of holes to the left and right of the central opening.
Ensure the positing leaves enough space for the reader's bezel to sit flat against the machine's panel and for the reader to be inserted into the machine and allow for the CAT5 cables to be connected.
Cut out the central opening and use a 9/64" Drill Bit to make a hole at each drill marks to the left and right of the central opening.
Place the C-0930 Mounting Bracket on the inside of the machine's panel. Pass through and connect the CAT5 cables and machine start harness to the reader.
Use the (2) C-0144 8-32 x 2" Flat Screw to attach the reader to the C-0930 Mounting Bracket.
Apply C-0015 Label over the area around the card slot on the front of the LaundryCard reader.
Â