_919

Owned by Chris Kite
Jan 24, 2024
1 min read

 I-M0143

Part #: C-5027

Desc 1: Label

Desc 2: Credit Card Logo

   Qty: 1

Part #: C-0133

Desc 1: Standoff

Desc 2: 8-32" x 1-1/2" - Hex

   Qty: 2

Part #: C-0925A

Desc 1: Mounting Bracket

Desc 2: For Coin Vault Mounting

   Qty: 1

Part #: C-0925B

Desc 1: Mounting Bracket

Desc 2: For Coin Vault Mounting

   Qty: 1

Part #: C-0964

Desc 1: Drop Cover

Desc 2: IPSO - Square

   Qty: 1

Part #: C-1044N

Desc 1: Nut

Desc 2: M3 - Kep

   Qty: 4

Part #: C-5751

Desc 1: Screw

Desc 2: 8-32 x 2-1/2" - Flat

   Qty: 2

  1. Remove the coin drop and coin box.

  2. Insert the C-0964 Coin Drop Cover into the coin drop opening and secure using the (4) C-1044N M3 Keps Nuts.

  3. Insert the C-0925A Vault Mounting Bracket into the coin vault so that the threaded stud are on the bottom and the flat face is pointed outwards from the vault.

  4. Attach the (2) C-0133 8-32 x 1-1/2" Standoffs to the threaded studs on the C-0925A Vault Mounting Bracket.

  5. Do not continue with the remaining steps until after installing the power and start harnesses and running them through the machine's coin vault opening and then through the openings in the C-0925A and C-0925B Vault Mounting Brackets.

  6. Connect both the power and start harnesses to the card reader.

  7. Place the C-0925B Vault Mounting Bracket over the coin vault, so the holes line up with the threaded studs on C-0925A and the guides line up with the edges of the machine's coin vault opening.

  8. Insert the (2) C-5751 8-32 x 2-1/2" Phillips Machine Screws in the mounting holes of the card reader and then through the holes in the C-0925B Vault Mounting Bracket.

  9. Attach the card reader and C-0925B Vault Mounting Bracket to the C-0925A Vault Mounting Bracket using the (2) C-5751 8-32 x 2-1/2" Phillips Machine Screws.

  10. Optional: Apply the C-5027 Label on or near the card reader for any accepted credit card issuers.