_887

Owned by Chris Kite
Jan 25, 2024
1 min read

 I-C0014

Part #: C-6334-3

Desc 1: Combination Harness

Desc 2: 3 Wire

   Qty: 1

Coin Sense

If installing C-6334-3 Combination Harness in a coin and card setup, perform the following steps:

  1. Disconnect the Coin Drop wires from micro switch.

  2. Connect the two female spade connectors on the blue wires of the C-6334-3 Combination Harness to the micro switch where the factory wires were previously connected.

Start

  1. Take the two wires originally connected to the machine's coin drop micro switch and connect them to the male spade connectors on the C-6334-3 Combination Harness.

    1. Connect the ground wire (2G) to the white wire labeled "COM".

    2. Connect the signal wire (503) to the purple wire labeled "NO".

    3. Connect the signal wire (501) to the brown wire labeled "NC".

  2. Locate the door switch and disconnect the wires connected to the microswitch and connect them to the white wires with the male spade connectors.

  3. Connect the remaining set of white wires with the female spade connectors to the door switch.