Overview

This page is intended to guide the user through the replacement of the local card reader on the X-Changer cabinet.

Disconnect any electrical device from power before performing any work on the device. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks.

Card Concepts Inc. takes no responsibility for the accuracy of this document or any damage that may occur to target equipment. Technical Support recommends using all appropriate safety equipment (such as hand and eye protection) during execution of the instructions below.

Recommended Tools and Supplies (Not Included)

No.2 Phillips Screwdriver (Or Equivalent)
3/32" Head Allen Hex Screwdriver (Or Equivalent)
1/4" Nut Driver
Utility Knife

Additional Information

Card Reader Programming Instructions

Browser not supported