How-to enable Card Reader Communications (Card Mode) on Machines

Machine Control Instructions Pre-ACA Controls Power Down the Machine. Connect the C-0110-CP Jumper plug to the H6 connection on the Machine Control Assembly. A-Micro Controls Enabling Card communication on Alliance A-Micro Washers ACA Controls Power Down the Machine. Flip Dipswitch 3 (on the Machine Control Board) to the 'ON' position. Leave all other dip switches as is. Alliance Touch Controls Navigate to System Menu Select Settings Select Vend Settings Select Payment Settings Under Serial/Pulse Interface Serial Payment System > Enable Card Reader > Enable Coin > Disable Titanium Controls Enabling card mode must be done at the machine programming level by setting the SErPAY option to "CArd" and CArdEn to "On".

Machine Control Instructions Giant-C Washers LG Giant-C Washer Programming 

Machine Control Instructions Continental Coin Control Continental Profit Plus Open washer door Press and hold the 1 key until 'Cod' appears on the display. Press 1,2,3,4,1,2,3,4 'Pro' appears on the display, press the 2 key repetitively until 'nod' appears on the display Press the 1 key repetitively until 'Id-0- appears on the display Press the 2 key one time, 'Id-1' appears on the display Press the 1 key one time Press the Stop key Continental HS7 Control (Touch) Enter the program menu: Swipe horizontally the upper left corner of the screen (Swipe at least 1/3 the way across the top of the screen for best results.). (If password is enabled) Enter the 4-digit numeric code (default: 1-2-3-4). Enabling card reader communication: Enter into the system settings menu. Select the Gear Icon Navigate to Connectivity > Internal GirNet. Enable the Active option. Changing the control from Pro to Vended mode Enter into the system settings menu. Select the Gear Icon, then navigate to General Settings > Control Type. Set the Control Type setting to Vended. More information + videos showing steps above:

Machine Control Instructions Crossover Enable Card Mode on Wascomat Crossover

Maytag machines do not have to be set in 'Card/Serial', they do, however, need to be in 'debit' mode (for card reader communication.) Maytag machines, regardless of which method used (Maytag MLV firmware, SingleVend (MLV+)), need to be set in 'Debit' mode.  For More information: Maytag Gen1 Configuration - LaundryCard Maytag Configuration - FasCard

Vending machines sometimes have to be set into "MDB CARD" mode (for card reader communication.) For example, the Crane 160 vending machine: For More information: Vend-Rite Equipment Information MDB Level 1 Vending Machines