3677 Reader Install Guide
- Chris Kite
- CCI Integration User
Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Washer Extractor
Manufacturer: Tolon
Make: Tolon
Model Length: 5
If sending multiple relay pulses to start machine, increase interval to 300ms or longer.
Associated Models
TWE10
TWE15
TWE18
TWE24
TWE28
TWE40
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Part #: C-6360
Desc 1: Coin Sense Harness
Desc 2: Female taps, Rq. Male
Qty: 1
Disconnect coin drop from factory machine harness.
Connect C-6360 Coin Sense Harness to the coin drop.
Connect red to red.
Connect green to brown.
Connect blue to blue.
Connect Machine Interface Harness
Part #: C-5256
Desc 1: Machine Start Harns (pulse)
Desc 2: 20" - Male taps, Rq. Female
Qty: 1
Connect the C-5256 Machine Start Harness to the harness originally connected to the coin drop.
Connect to the black and brown wires.
To prevent any potential electrical issues, apply electrical tape over the blue wire connector.