_1062

 I-M0213

Part #: C-6980

Desc 1: Maytag Bk Splash Mount

Desc 2: F2

   Qty: 1

Part #: C-1042

Desc 1: Nut

Desc 2: 8-32 - Kep

   Qty: 1

Part #: C-1070-W

Desc 1: Washer - Build: XCH

Desc 2: 1/4" x 1" O.D.

   Qty: 1

Part #: C-5416

Desc 1: Screw

Desc 2: 8-32" x 3/8" - Button - Torx

   Qty: 2

  1. Remove the front control panel by removing the (4) Torx screws and lifting up and away from the machine.

  2. Remove any existing card slot cover or insert from the card slot opening (A. - Figure 1).

    MAT12PR-CO-step01-20240125-045954.jpg
  3. Place the C-6980 Maytag TLW Bracket over the front of the panel. Ensure the upper-right hole (D. - Figure 2) lines up with the upper-right panel screw (B. - Figure 1) and so the threaded stud passes through the card slot opening (A. - Figure 1).

    MAT12PR-CO-step02-20240125-045957.jpg
  4. With the C-6980 Maytag TLW Bracket in place, use the bracket as a template to mark the location of the lower-right hole (E. - Figure 2) on the panel. Reinstall the panel onto the machine to drill through both the machine's control panel and bracket. Drill a hole using a 9/64" Drill Bit.

  5. Flip over the front panel so the inside face is accessible. Secure the C-6980 Maytag TLW Bracket to the panel using the C-1070-W 1/4" x 1" Washer and C-1042 8-32 Keps Nut (Figure 3)

    MAT12PR-CO-step03-20240125-045959.jpg
  6. Run the reader side of the C-5364 Machine Start Harness and C-5500 Power Extension Harness through the card slot opening.

    MAT12PR-CO-step04-20240125-050001.jpg
  7. Reattach front control panel to machine and use existing screws to affix the right side of the panel and C-6980 Maytag TLW Bracket through holes D. and E. (Figure 2.).