_1078

Owned by Chris Kite
Jan 24, 2024
1 min read

 I-X0027

Part #: C-0110-TOP-144

Desc 1: Machine Start Harness

Desc 2: 144" - Alliance Pre-ACA

   Qty: 1

Part #: C-5033

Desc 1: Label

Desc 2: 4-5/8" x 3-1/2"

   Qty: 1

Part #: C-0110-CP

Desc 1: Jumper Plug

Desc 2: Enables card mode on pre-ACA

   Qty: 1

Part #: C-6411

Desc 1: F3, MLV Stack Add On Dongle

Desc 2: Serial / MultiVend

   Qty: 1

The following steps assume the start and coin sense harnesses are already connected to the upper pocket control.

  1. Locate area to mount C-6411 Serial Stack Add-On Board.

    1. Must be close enough to reader mounting location to connect the harness to.

    2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)

  2. Clean mounting location to remove any dust and residue if needed.

  3. Remove the sticker from the back of the C-6411 Serial Stack Add-On Board to expose the adhesive and apply to the mounting location.

  4. Connect the white, 7-pin connector from the C-0110-TOP to the H3 connection on the lower pocket's Machine Control Assembly.

  5. Apply the C-5033 Label over the coin drop opening for the lower pocket.