_1080

Owned by Chris Kite
Jan 24, 2024
1 min read

 I-X0028

Part #: C-5300-NC-144

Desc 1: Machine Start Harness

Desc 2: 144" Alliance

   Qty: 1

Part #: C-6250-144

Desc 1: Coin Sense Harness

Desc 2: 144" length

   Qty: 1

Part #: C-6410

Desc 1: F3, SLV Stack Add On Dongle

Desc 2: Pulse / SingleVend

   Qty: 1

The following steps assume the start and coin sense harnesses are already connected to the upper pocket control.

  1. Locate area to mount C-6410 Pulse Stack Add-On Board.

    1. Must be close enough to reader mounting location to connect the harness to.

    2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)

  2. Clean mounting location to remove any dust and residue if needed.

  3. Remove the sticker from the back of the C-6410 Pulse Stack Add-On Board to expose the adhesive and apply to the mounting location.

  4. Connect the white, 6-pin connector from the C-5300-NC-144 Machine Start Harness to the J1 connection on the C-6410 Pulse Stack Add-On Board.

  5. Connect the white, 3-pin connector from the C-5300-NC-144 to the Coin 1 connection on the lower pocket's Machine Control Assembly.

  6. Connect the the green, 3-pin connector from the C-6250-144 Coin Sense Harness to the lower pocket's Coin Drop.