3407 Reader Install Guide
- Chris Kite
- CCI Integration User
Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Washer
Manufacturer: Maytag
Make: Maytag
Model Length: 10
Customer will need to confirm which type of coin drop connection is used on their machines.
Associated Models
MFR15PDAVS
MFR18PDCTS
MFR18PDCW8
MFR18PDCWS
MFR20PDAVS
MFR20PDCTS
MFR25PDCWS
MFR30PDAVS
MFR30PDCTS
MFR35PDATS
MFR35PDAVS
MFR35PDCTS
MFR40PDCTS
MFR40PDTTS
MFR50PDATS
MFR50PDAVS
MFR50PDCTS
MFR60PDCTS
MFR60PDCWS
MFR80PDAVS
MFR80PDCTS
MFS35PDFTS
MFS50PDFTS
MFS80PDFTS
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Part #: C-5360
Desc 1: Coin Sense Harness
Desc 2: Female taps, Rq. Male
Qty: 1
Disconnect the Red, Blue, and (2) Green wires from the coin drop termination block spade connections and connect the C-5360 Coin Sense Harness in place of the disconnected wires, matching the corresponding colors.
Part #: C-6360
Desc 1: Coin Sense Harness
Desc 2: Female taps, Rq. Male
Qty: 1
Disconnect the Red, Blue, and (2) Green wires from the coin drop termination block spade connections and connect the C-6360 Coin Sense Harness in place of the disconnected wires, matching the corresponding colors.
Part #: C-6360
Desc 1: Coin Sense Harness
Desc 2: Female taps, Rq. Male
Qty: 1
Disconnect the coin drop from the machine control assembly and connect to the C-6362 Coin Sense Harness.