3251 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Stack Washer/Dryer
Manufacturer: Alliance
Make: [VARIES]
Model Length: 15

W: Alliance ACA Front-Load Washer - MDC II
D: Alliance MDC II Small Dryer

If equipped with electronic coin drop that uses existing H10 power connector, send I-P0007 power kit instead.

Models with "6" as the 11th character, can be equipped with Titanium controls instead. If so, I-P0007 power kits are needed instead.

Associated Models

HTEBCASP175TW01
HTEBYASP285CW01
HTGBCAPS116TW01
HTGBCASP115TW01
HTGBCASP116EW01
HTGBCASP116TW01
HTGBYASP115TW01
HTGBYASP116TW01

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Connect Power

I-P0018

Part #: C-6204

Desc 1: Power Adapter Harness

Desc 2: F2 12vDC Power Harness

Qty: 1

Connect the C-6204-40 12VDC Power Harness to the H10 connection on the Machine Control Assembly.
1. Connect the green wire to a chassis ground.
The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

Connect Coin Sense Harness

I-S0027

Part #: C-6250

Desc 1: Coin Sense Harness

Desc 2: F2

Qty: 1

Disconnect the Coin Drop from the machine control assembly.
Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

Machine Configuration

CCI Software Configuration

Machine Control	Pulse	Serial
MDC II (A1)	SingleVend (MLV+) / 80ms	Alliance ACA H7S Small Dryer A1 - MDC II
MDC II (A1)	SingleVend (MLV+) / 80ms	Alliance ACA H7S Front Load Washer A1 - MDC II

CCI Documentation