3208 Reader Install Guide

Owned by Chris Kite
Last updated: Jan 26, 2024 by CCI Integration User
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Vending
Manufacturer: Wittern
Make: Wittern
Model Length: Not Set

This entry covers a large portion of Wittern machines. As they all share the same installation requirements and only slightly vary. Photos are not applicable to all models.

Associated Models

3503
3535
3536
3537
3538
3539
3573
3574
3575
3576
3578
36 SELECT LAUNDRY CENTER
FEDERAL MACHINE: 25/27/28 SELECT
FEDERAL MACHINE: 30/40/45 SELECT
MERCATO 5000
MZF3000
USI: ALPINE 5000 ELEVATOR
USI: ALPINE ST3000/VT3000
USI: ALPINE ST5000/VT5000
USI: WS3000/WS4000/WS5000/WS6000

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Power is supplied through the same Machine Interface Harness described in step 4.

Connect Coin Sense Harness

No COIN SENSE kits exist for this equipment.

Not applicable in this setup. FasCard reader does not collect payment from any other devices, and will only send funds to the machine's control.

CCI Software Configuration

Machine ControlPulseSerial
MDB*NOT SUPPORTED*Vending - MDB Level 1

Additional Resources