3489 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Washer
Manufacturer: Wascomat
Make: Wascomat
Model Length: Not Set

Associated Models

WHLFP715C2DC
WHLFP715C2FMI
WHLFP715DC
WHLFP715M
WHLFP817M

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Connect Power

I-P0016

Part #: C-5350

Desc 1: Power Adapter Harness

Desc 2: Crossover

Qty: 1

Connect the C-5350 Power Adapter Harness to the 2-pin power connector bundled with the CN4 serial communication harness connection near the payment device opening inside the machine.
Secure the green ground wire under a machine chassis screw.

Instructions do not exist for Kit I-P0030

Connect Machine Interface Harness

I-T0062

Part #: C-5355

Desc 1: Machine Start Harness