3697 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Tumble Dryer (Single)
Manufacturer: ONNERA Group
Make: [VARIES]
Model Length: Not Set

Associated Models

UDTT135G
UDTT25G
UDTT80G

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Connect Power

I-P0012

Part #: C-5101

Desc 1: Spade Taps

Desc 2: 18-14 AWG

Qty: 3

Part #: C-5210

Desc 1: Power Adapter Harness

Desc 2: CGI

Qty: 1

Part #: C-5500-60

Desc 1: Power Extension Harness

Desc 2: 60"

Qty: 1

Part #: C-5602R1

Desc 1: Power Converter

Desc 2: SMT-012-018VW

Qty: 1

Tap the machine AC power wires using the C-5101 Spade Taps. See FasCard Reader Install - Universal Concepts for more details.
1. For 120vac models: L1, N, and Ground wires
2. For 240vac models: L1, L2, and Ground wires
Connect the three wires from the C-5210 Power Adapter Harness to the C-5101 Spade Taps.
1. Connect the Blue wire to the L1 tap.
2. Connect the Brown wire to the N/L2 tap.
3. Connect the Green/Yellow wire to the Ground tap.
Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connector on the C-5602R1 Power Converter.
Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connector on the C-5500-60 Power Extension Harness.
Run the C-5500-60 Power Extension Harness to the reader mounting location.

Connect Coin Sense Harness

I-S0061

Part #: C-5372

Desc 1: F1 Coin Sense

Desc 2: Coin Sense Harness

Qty: 1

Disconnect the coin drop 6-pin connection from the machine.
Connect the C-5372 Coin Sense Harness to the coin drop.

I-S0062

Part #: C-6373

Desc 1: F2 Coin Sense

Desc 2: Coin Sense Harness

Qty: 1

Disconnect the coin drop 6-pin connection from the machine.
Connect the C-6373 Coin Sense Harness to the coin drop.

Connect Machine Interface Harness

I-T0095

Part #: C-5374R1

Desc 1: FC-LC Start Harness

Desc 2: Pulse Start Harness

Qty: 1

If coin drop is present, disconnect the coin drop from the extension harness for the CN8 connection and connect the C-5374R1 Pulse Start Harness to the 6-pin connector on the extension harness.