3660 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Small Dryer (Single)
Manufacturer: Whirlpool
Make: Whirlpool
Model Length: 10

Associated Models

CED9050AWO
CGD9050AW0
CGD9050AW1

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Connect Power

I-P0007

Part #: C-5101

Desc 1: Spade Taps

Desc 2: 18-14 AWG

Qty: 2

Part #: C-5336

Desc 1: Power Adapter Harness

Desc 2: Dexter Stack

Qty: 1

Part #: C-5500

Desc 1: Power Extension Harness

Desc 2: 25.5"

Qty: 1

Part #: C-5602R1

Desc 1: Power Converter

Desc 2: SMT-012-018VW

Qty: 1

Tap power as described in the FasCard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
1. 120vac: Connect the blue wire to L1 and the brown wire to N.
2. 240vac: Connect the blue wire to L1 and the brown wire to L2.
3. Secure the green wire to the ground screw.
Connect the C-5336 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Connect Coin Sense Harness

I-S0020

Part #: C-5362

Desc 1: Coin Sense Harness

Desc 2: MLG

Qty: 1

Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-5362 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

I-T0004

Part #: C-5364

Desc 1: Machine Start Harness

Desc 2: Maytag MFR

Qty: 1

Connect the C-5364 Machine Start Harness to the AA3 (Debit) connector on the Machine Control Assembly.

Extras

No EXTRAS kits exist for this equipment.

Machine Configuration

Enter Service Mode and navigate to J option.
Set option to J.d.
Exit Service Mode.

CCI Software Configuration

Machine Control	Pulse	Serial
Gen1	SingleVend (MLV+) / 24ms	NOT SUPPORTED

CCI Documentation

3660 Reader Install Guide

Overview

Equipment Details

Associated Models

Recommended Tools and Supplies

Installation

Connect Power

Connect Coin Sense Harness

Connect Machine Interface Harness

Extras

Machine Configuration

CCI Software Configuration

Additional Resources

Related pages