3660 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Small Dryer (Single)
Manufacturer: Whirlpool
Make: Whirlpool
Model Length: 10

Associated Models

CED9050AWO
CGD9050AW0
CGD9050AW1

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Extras

No EXTRAS kits exist for this equipment.

Machine Configuration

Enter Service Mode and navigate to J option.
Set option to J.d.
Exit Service Mode.

CCI Software Configuration

Machine Control	Pulse	Serial
Gen1	SingleVend (MLV+) / 24ms	NOT SUPPORTED

CCI Documentation