0116 Reader Install Guide

Owned by Chris Kite
Last updated: Apr 01, 2024 by David Bussman
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Tumble Dryer (Stack)
Manufacturer: Laundrylux
Make: Electrolux
Model Length: 6

Associated Models


T4300S
T4330S
T43OOS
T4420S
T4425S
T4440S

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

 I-S0017

Part #: C-5358

Desc 1: Coin Sense Harness (SA)

Desc 2: TD

   Qty: 1

  1. Disconnect the Coin Drop from the Machine Control Assembly.

  2. Connect the C-5358 Coin Sense Harness to the harness connected to the Coin Drop.

    1. Match each of the colored wires from the coin drop to the matching wire on the coin sense harness.

 I-T0014

Part #: C-0111-RES

Desc 1: Machine Start Harness

Desc 2: Two Wire Harness w/ Resistor

   Qty: 1

  1. Connect the C-5356 Machine Start Harness to Position 2 and 3 on the coin connection terminal on the Machine Control Assembly.