_999

Owned by Chris Kite
Last updated: Jan 24, 2024
2 min read

 I-P0026

Part #: C-1098

Desc 1: 3M Dual Lock 1" wide

Desc 2: Use 4" strips for C-5602

   Qty: 1

Part #: C-5101

Desc 1: Spade Taps

Desc 2: 18-14 AWG

   Qty: 2

Part #: C-5336

Desc 1: Power Adapter Harness

Desc 2: Dexter Stack

   Qty: 1

Part #: C-5500

Desc 1: Power Extension Harness

Desc 2: 25.5"

   Qty: 1

Part #: C-5602R1

Desc 1: Power Converter

Desc 2: SMT-012-018VW

   Qty: 1

  1. Locate the 120v power lines in the machine. These wires are usually black and white and are located just inside the back of the panel. Use a voltage tester to confirm the correct wiring.

    image-20240125-040523.png

  2. Apply the C-5101 Spade Taps to both the black and white power wires and clamping them down with pliers.

    image-20240125-040538.png

  3. Plug the brown wire of the C-5336 Power Adapter Harness to the white/neutral wire tap and the blue wire to the black/L1 wire tap.

    image-20240125-040551.png

  4. Locate a green chassis ground screw and loosen to insert the green wire from the C-5336 Power Adapter Harness and retighten.

    image-20240125-040625.png

  5. Connect the 3-pin connector from the C-5336 Power Adapter Harness to the C-5602R1 Power Converter.

    image-20240125-040639.png

  6. Apply the C-1098 Velcro to the C-5602R1 Power Converter and secure inside the machine's panel.

    image-20240125-040653.pngimage-20240125-040700.png

  7. Connect the 4-pin connector from the C-5500 Power Extension Harness to the C-5602R1 Power Converter.

  8. Route the 3-pin connector from the C-5500 Power Extension Harness through the open card slot on the machine control panel.

    image-20240125-040722.png