0877 Reader Install Guide

Owned by Chris Kite
Last updated: Jan 26, 2024 by CCI Integration User
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Stack Washer/Dryer
Manufacturer: Dexter
Make: Dexter
Model Length: 11

This is the dryer portion of a stacked unit. Will be paired with a washer unit as well.

Associated Models


DSTD30KCS10
DSTD30KCS10TS

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

  1. 120vac: Use connectors #2 closest to outside of machine and #4 on terminal side closest to circuit board.

  2. 240vac: Use connectors #3 and #5 on the terminal side closest to the circuit board.

CCI Software Configuration

Machine ControlPulseSerial

Additional Resources