2014 Reader Install Guide

Owned by Chris Kite
Last updated: Jan 26, 2024 by CCI Integration User
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Dryer
Manufacturer: Maytag
Make: Maytag
Model Length: Not Set

• 1) If factory coin drop adapter harness is not available and coin drop connection on board is not compatible with C-5344 start harness, use C-5302 start harness.

Associated Models


MDG32PC2AL
MDG32PC3AL
MDG32PC3AW
MDG32PC3AW1

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

CCI Software Configuration

Machine ControlPulseSerial
*NO NAME*SingleVend (Relay) / 50ms*NOT SUPPORTED*

Additional Resources