3447 Reader Install Guide
- Chris Kite
- CCI Integration User
Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Vending
Manufacturer: Seaga
Make: Seaga
Model Length: Not Set
Associated Models
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Power is supplied through the same Machine Interface Harness described in step 4.
Connect Coin Sense Harness
No COIN SENSE kits exist for this equipment.